Never ending WU's ?

Message boards : Number crunching : Never ending WU's ?
Message board moderation

To post messages, you must log in.

1 · 2 · Next

AuthorMessage
Profile [AF>Amis des Lapins] Phil1966

Send message
Joined: 24 Oct 20
Posts: 1
Credit: 4,526,419
RAC: 0
Message 703 - Posted: 21 Mar 2021, 11:19:25 UTC

Hello

have 8 WU's looking like they will never end... ? (running since 10 up to 14 hours)

11346342 6932272
11346025 6932114
11339666 6928940
11338798 6928506
11323960 6921102
11317557 6917909
11317569 6917915
11317615 6917938
ID: 703 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
Spectrum

Send message
Joined: 26 Dec 20
Posts: 11
Credit: 1,176,097
RAC: 2,062
Message 704 - Posted: 21 Mar 2021, 12:02:04 UTC - in response to Message 703.  

What was the runtime before?

Since yesterday we are cruncing on the fifth target: https://www.sidock.si/sidock/forum_thread.php?id=97

Please note that these new workunits can run five times as long as the old WUs, so it seems pretty normal to me. These are just way bigger WUs.
ID: 704 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
shift
Avatar

Send message
Joined: 6 Feb 21
Posts: 8
Credit: 365,844
RAC: 473
Message 706 - Posted: 21 Mar 2021, 13:04:26 UTC - in response to Message 703.  

My tasks have gone from 2000-3000 sec to 17000-20000 sec. Credit increased too so it's not all bad!
ID: 706 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
Rasputin42

Send message
Joined: 12 Jan 21
Posts: 13
Credit: 2,513,888
RAC: 0
Message 707 - Posted: 21 Mar 2021, 14:56:41 UTC
Last modified: 21 Mar 2021, 15:23:23 UTC

Maybe it is a good time to think about breakpoints?
If it is not already implemented,that is.
Sorry, i ment checkpoints.
ID: 707 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
Matthias Lehmkuhl

Send message
Joined: 16 Jan 21
Posts: 4
Credit: 2,445,195
RAC: 1,182
Message 716 - Posted: 21 Mar 2021, 17:47:09 UTC - in response to Message 706.  

most of my results are too round 22000 seconds
my highest run time so far was 38000 seconds (more than 10 hours)
https://www.sidock.si/sidock/workunit.php?wuid=6927206

so a deadline with at least 3 days would be very helpful

and for this run time longer than 2 hours I would too like to have check pointing on the results
Matthias
ID: 716 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
Crystal Pellet

Send message
Joined: 26 Oct 20
Posts: 53
Credit: 2,520,836
RAC: 0
Message 720 - Posted: 21 Mar 2021, 18:41:24 UTC

My longest CPU time: 14 hours 30 min 28 sec
ID: 720 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
PMH_UK

Send message
Joined: 23 Dec 20
Posts: 20
Credit: 1,360,768
RAC: 0
Message 725 - Posted: 22 Mar 2021, 17:43:18 UTC - in response to Message 720.  

I had 20 hours on a slow PC, much shown as a few minutes time remaining.

Paul.
ID: 725 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
Thyme Lawn

Send message
Joined: 18 Dec 20
Posts: 3
Credit: 421,604
RAC: 0
Message 728 - Posted: 22 Mar 2021, 21:14:34 UTC

My 4GHz i7-6700K Windows 10 system limits BOINC to using 7 CPUs. It downloaded 14 of the corona_Eprot tasks yesterday, with each of them having a 48-hour deadline and a 70-minute runtime estimate.

The first task took 9 hours, the second 9.5 hours. The deadline is now less than 16 hours away, but Boinc doesn't recognise there's a problem because the estimated runtime (calculated using the workunit's rsc_fpops_est value)
is out by a factor of at least 8. I'm expecting some of the 12 pending tasks to miss their deadline and others to be cancelled by the server because they haven't been started before their deadline.
"The ultimate test of a moral society is the kind of world that it leaves to its children." - Dietrich Bonhoeffer
ID: 728 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
hoarfrost
Volunteer moderator
Project administrator
Project developer

Send message
Joined: 11 Oct 20
Posts: 334
Credit: 25,583,586
RAC: 6,772
Message 729 - Posted: 22 Mar 2021, 21:37:31 UTC - in response to Message 728.  

Next bunches of tasks will be created with increased value rsc_fpops_est.
ID: 729 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
albuka

Send message
Joined: 30 Dec 20
Posts: 7
Credit: 7,850,014
RAC: 0
Message 739 - Posted: 25 Mar 2021, 7:12:01 UTC

nothing changed. processing time is set to 40 minutes, and the job is running for 2 hours or more
ID: 739 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
PMH_UK

Send message
Joined: 23 Dec 20
Posts: 20
Credit: 1,360,768
RAC: 0
Message 740 - Posted: 25 Mar 2021, 8:11:10 UTC - in response to Message 739.  

Were they re-sends?
I had several re-sends from time-outs/no replies/aborts that had old short estimate.
Now got some with longer estimates.

Paul.
ID: 740 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
albuka

Send message
Joined: 30 Dec 20
Posts: 7
Credit: 7,850,014
RAC: 0
Message 741 - Posted: 25 Mar 2021, 11:12:44 UTC
Last modified: 25 Mar 2021, 11:45:02 UTC

now it’s much better, of course, but not as good as rosetta@home.
If 8 hours are assigned to the task, this will be the case (+- some minutes)
sidock is not so accurate - they plan two hours on a job, but it actually works four
doesn’t that interfere with the other projects boinc scheduler’s work ?
ID: 741 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
Jim1348

Send message
Joined: 30 Oct 20
Posts: 57
Credit: 9,112,528
RAC: 0
Message 742 - Posted: 25 Mar 2021, 15:17:46 UTC - in response to Message 741.  

sidock is not so accurate - they plan two hours on a job, but it actually works four

It goes the other way with me on two Ryzen 3950s. They run between 5 and 6 hours, but the estimates are 9 hours on one machine, and 12 hours on the other.
They should be converging to the correct value by now, but are correcting more slowly than usual.
ID: 742 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
hoarfrost
Volunteer moderator
Project administrator
Project developer

Send message
Joined: 11 Oct 20
Posts: 334
Credit: 25,583,586
RAC: 6,772
Message 744 - Posted: 26 Mar 2021, 4:02:43 UTC
Last modified: 26 Mar 2021, 4:11:30 UTC

Hi folks!

Estimate execution time, displayed by BOINC client, computed by it in last several days, may be two weeks and number of estimated flops for task. After increasing rsc_fpops_est in 2.5 times estimated time on my Ryzen up top ~09:45:00, but real execution time ~ 05:45. But, I think, after several days estimate time will be close to actual.
ID: 744 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
albuka

Send message
Joined: 30 Dec 20
Posts: 7
Credit: 7,850,014
RAC: 0
Message 745 - Posted: 26 Mar 2021, 5:20:57 UTC

i have one more question, perhaps off topic.
why the tasks are reset after stopping, and do not start from the moment where they were interrupted ?
rosetta do so
ID: 745 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
der_Day

Send message
Joined: 9 Feb 21
Posts: 7
Credit: 7,463,815
RAC: 4,019
Message 746 - Posted: 26 Mar 2021, 12:04:22 UTC - in response to Message 745.  
Last modified: 26 Mar 2021, 12:05:45 UTC

because the WUs have no checkpoints
see also this thread: https://www.sidock.si/sidock/forum_thread.php?id=17
ID: 746 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
Jim1348

Send message
Joined: 30 Oct 20
Posts: 57
Credit: 9,112,528
RAC: 0
Message 747 - Posted: 26 Mar 2021, 15:08:35 UTC - in response to Message 744.  

But, I think, after several days estimate time will be close to actual.

Yes, they have converged to 7 hours on one Ryzen 3950X, and 8 hours on the other, which are much closer to the actual time of about 5 1/2 hours.
ID: 747 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
albuka

Send message
Joined: 30 Dec 20
Posts: 7
Credit: 7,850,014
RAC: 0
Message 753 - Posted: 28 Mar 2021, 15:37:21 UTC - in response to Message 747.  

five with the planned eight is better than eight with the planned five )
ID: 753 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
hoarfrost
Volunteer moderator
Project administrator
Project developer

Send message
Joined: 11 Oct 20
Posts: 334
Credit: 25,583,586
RAC: 6,772
Message 757 - Posted: 30 Mar 2021, 6:19:35 UTC

And, some tasks, as usual can be computing longer than others. But credit is also larger.
ID: 757 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
Sven Scheuch

Send message
Joined: 30 Jan 21
Posts: 2
Credit: 5,699,688
RAC: 4,067
Message 1630 - Posted: 21 May 2022, 6:04:29 UTC - in response to Message 703.  

Just aborted 62895949 after nearly 12h CPU runtime and showing 45% progress.
WU's come in showing a runtime of 5.5h. I would like to see the expected runtime somewhat more accurate if WU's run normal.
There seems to be quite a big spread in runtimes. Other projects are more predictable.
ID: 1630 · Rating: 0 · rate: Rate + / Rate - Report as offensive     Reply Quote
1 · 2 · Next

Message boards : Number crunching : Never ending WU's ?

©2024 SiDock@home Team